Canon i-SENSYS MF6540

Procedure after Replacing the CS

After replacing the contact sensor (CS), go through the following steps to perform inter-channel output correction:

1. Enter the service mode. Sequentially press the Additional functions key, 2 key, 8 key, and Additional functions key on the operation panel.
2. Press the arrow key on the touch panel to display "TEST MODE".
3. Press [OK].
4. Press the [2] key to display "SCAN TEST".
5. Press the [1] key to display "SHADING".
6. Press [OK].

After completion of the above procedure, the contact sensor output is compensated and parameters are set automatically.

After completion of automatic adjustment, "OK" is displayed.