Canon MF810Cdn
Service Mode. COPIER. DISPLAY. 2 ANALOG
ANALOG
COPIER> DISPLAY> ANALOG | ||
---|---|---|
TEMP | Display of outside temperature | |
Details | To display the temperature outside the machine. This is measured by the Environment Sensor 2 that detects the outside air. |
|
Use case | When checking the temperature outside the machine | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 60 | |
Unit | 1 deg C | |
Appropriate target value | 20 - 27 | |
HUM | Display of outside humidity | |
Details | To display the humidity outside the machine. This is measured by the Environment Sensor 2 that detects the outside air. |
|
Use case | When checking the humidity outside the machine | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 5 to 90 | |
Unit | 1 % | |
Appropriate target value | 30 - 70 | |
ABS-HUM | Display of outside moisture amount | |
Details | To display the absolute moisture amount outside the machine. This is measured by the Environment Sensor 2 that detects the outside air. | |
Use case | When checking the moisture amount outside the machine | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 100 | |
Unit | 1 g | |
Appropriate target value | 0 - 22 | |
FIX-E | Dspl of Fixing Main Heater temperature | |
Details | To display the temperature of the Fixing Main Heater detected by the Main Thermistor 1. | |
Use case | When checking the temperature of Fixing Main Heater | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 300 | |
Unit | 1 deg C | |
FIX-E2 | Dspl Fixing Sub Heater front edge temp | |
Details | To display the front edge temperature of the Fixing Sub Heater detected by the Sub Thermistor 1. | |
Use case | When checking the edge temperature of the Fixing Sub Heater | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 300 | |
Unit | 1 deg C | |
TEMP2 | Display of inside temperature | |
Details | To display the estimated temperature inside the machine that is calculated from the outside temperature and elapsed time. | |
Use case | When checking the estimated temperature inside the machine | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 100 | |
Unit | 1 deg C | |
Appropriate target value | Room temperature - Room temperature+15 deg C | |
Related service mode | COPIER> DISPLAY> ANALOG> TEMP | |
FIX-E3 | Dspl of Fixing Sub Heater rear edge temp | |
Details | To display the rear edge temperature of the Fixing Sub Heater detected by the Sub Thermistor 2. | |
Use case | When checking the edge temperature of the Fixing Sub Heater | |
Adj/set/operate method | N/A (Display only) | |
Display/adj/set range | 0 to 300 | |
Unit | 1 deg C |