Brother MFC8530DN
Troubleshooting. 2.2 No paper is fed from LT
User Check
• Check that the paper is set in the paper tray correctly.
• Check that there is not too much paper set in the paper tray.
• Flip over the paper in the paper tray or rotate the paper 180°.
• Check that the thickness of the paper is 60 to 120 g/m2 (paper tray 2 to 4).
• Check that the MP tray, T1 or TT is not set as the paper tray.
• Flip through the paper and reset it in the paper tray.
• Clean the paper pick up roller.
• Install the latest main firmware.
Step | Cause | Remedy |
---|---|---|
1 | Dirt on a paper dust cleaning roller of the paper tray | Clean the appropriate paper dust cleaning roller. |
2 | Attachment failure of a roller holder ASSY | Reattach the appropriate roller holder ASSY correctly. |
3 | Connection failure of the paper feed motor harness | Reconnect the paper feed motor harness. |
4 | Connection failure of an LT paper feed sensor harness | Reconnect the appropriate LT paper feed sensor harness. |
5 | Connection failure of an LT control PCB flat cable | Reconnect the appropriate LT control PCB flat cable. |
6 | Connection failure of an LT release clutch harness | Reconnect the appropriate LT release clutch harness. |
7 | Connection failure of an LT pickup clutch harness | Reconnect the appropriate LT pickup clutch harness. |
8 | An LT paper empty actuator coming off | Reattach the appropriate LT paper empty actuator. |
9 | Abrasion of a paper pick up roller | Replace the appropriate PF kit. |
10 | An LT release clutch failure | Replace the appropriate LT release clutch. |
11 | An LT pickup clutch failure | Replace the appropriate LT pickup clutch. |
12 | An LT paper empty sensor failure | Replace the appropriate LT paper empty sensor PCB ASSY. |
13 | Damaged a plate gear | Replace the appropriate plate gear. |
14 | Damaged fuser gear | Replace the fuser gear. |
15 | Damaged an LT/TT connector | Replace the appropriate LT/TT connector. |
16 | Paper feed motor failure | Replace the paper feed motor. |
17 | An LT control PCB failure | Replace the appropriate LT control PCB ASSY. |
18 | Panel PCB failure | Replace the panel PCB ASSY. |
19 | Damaged LT drive gear system of the machine | Replace the main frame L ASSY. |
20 | Damaged fuser unit | Replace the fuser unit. |
21 | Main PCB failure | Replace the main PCB ASSY. |