Brother MFC-L2720DW
Troubleshooting. 2.1 No paper is fed from paper tray
User Check
• Check that the paper is set in the paper tray correctly.
• Check that there is not too much paper set in the paper tray.
• Flip over the paper in the paper tray or rotate the paper 180°.
• Check that the thickness of the paper is 60 to 105 g/m2.
• Check that the manual feed slot is not set as the pick-up tray.
• Flip through the paper and reset it in the paper tray.
• Clean the pick-up roller.
Step | Cause | Remedy |
---|---|---|
1 | Accumulated paper dust | Remove the paper dust cleaning roller cover and get rid of the paper dust in the area described in the figure below. |
2 | Roller holder ASSY attachment failure | Reattach the roller holder ASSY correctly. |
3 | Connection failure of the main motor flat cable | Reconnect the main motor flat cable. |
4 | Connection failure of the paper feed sensor harness | Reconnect the paper feed sensor harness ASSY. |
5 | Paper feed actuator coming off | Reattach the paper feed actuator. |
6 | Connection failure of the new toner sensor PCB flat cable | Reconnect the new toner sensor PCB flat cable. |
7 | Connection failure of the T1 clutch harness | Reconnect the T1 clutch harness. |
8 | Abrasion of the pick-up roller | Replace the PF kit. |
9 | T1 clutch failure | Replace the T1 clutch. |
10 | Damaged P/P gear | Replace the paper tray. |
11 | Main motor failure | Replace the main motor. |
12 | Damaged gears in the paper feeding system | Replace the main frame L ASSY. |
13 | Damaged fuser unit | Replace the fuser unit. |
14 | Main PCB failure | Replace the main PCB ASSY. |