Brother HL-L3230CDW
Troubleshooting. 2.5 Paper is fed at an angle, Paper curls
2.5 Paper is fed at an angle
User Check
• Check that the paper is set in the T1 correctly.
• Flip over the paper in the T1 or rotate the paper 180°.
• Adjust each paper guide according to each paper size.
• Check that the thickness of the paper is 60 to 163 g/m2.
• Check that there is not too much paper set in the T1.
• Check that the type of paper is appropriate.
• Clean each paper pick up roller.
• Check that the green envelope lever of the fuser cover is not lowered on only one side.
Step | Cause | Cause |
---|---|---|
1 | One-side abrasion of the paper pick up rollers | Replace the appropriate PF kit 1. |
2 | Paper feed unit failure | Replace the paper feed unit. |
2.6 Paper curls
User Check
• Change the driver setting to be matched with the size of the paper set in the T1.
• Select “Reduce Paper Curl” in the driver.
• Check that the paper is set in the T1 correctly.
• Open the back cover and try printing with straight paper ejection mode.
Step | Cause | Cause |
---|---|---|
1 | Fuser unit failure | Replace the fuser unit. |
2 | Main PCB failure | Replace the main PCB. |