Description: A paper jam was detected at the feed sensor. 1. The feed sensor is defective. 2. The Regi Roller was contaminated or worn out. 3. There is some obstacles in the paper path. 4. The driving for the toner cartridge has some problem. 5. The driving for the fuser unit has some problem.
Remedy: 1. Remove the jammed paper. If the error persists, check the followings. 2. Check if the feed sensor connector is connected properly. Feed sensor Regi. sensor 3. Check if the Regi roller is contaminated or worn out. If yes, replace it. 4. Check if there is any obstacles or contamination in the paper path. If yes, clean or remove it.
Code: M2-2310
Display: Paper Jam bottom of duplex.
Description: A paper jam was detected in the bottom of duplex. 1. There is some obstacles in the paper path. 2. The paper guide in the tray was not adjusted properly. 3. The exit sensor was not assembled properly.
Remedy: 1. Remove the jammed paper. 2. Remove the contamination or obstacles in the paper path. 3. Adjust the paper guide properly. 4. Check if the exit sensor is assembled properly. Reassemble it.
Code: M3-1110
Display: Paper Jam in exit area.
Description: A paper jam was detected in the exit area. 1. There is some obstacles in the paper path.
Remedy: 1. Remove the jammed paper. 2. Check if there is any obstacles or contamination in the paper path. If yes, clean or remove it.
Code: M3-2130
Display: Output bin full. Remove paper.
Description: The machine detected that the output tray has got full or the bin-full sensor is defective. 1. Output tray is full. 2. Outbin full sensor connection is wrong.
Remedy: 1. Remove the paper on the output tray. (The maximum loading capacity is 150 sheets based on standard paper(80g/m2).) 2. Check if the Bin-full Sensor connector is connected properly. Reconnect it or replace the Bin-full sensor.
Code: S1-2411
Display: Error #S1-2411 Turn off then on.
Description: A communication error failure has occurred at HDD of main controller.
Remedy: 1. Format the hard disk. 2. If the problem persists, replace the hard disk.
Code: S2-4110
Display: Door open. Close it.
Description: Door is open or the cover open switch is defective. The status LED is red.
Remedy: 1. Check if the front door is closed perfectly. 2. Check if the rear door is closed perfectly. 3. Check if the connection between the main board and HVPS board is correct. 4. Check if the cover open switch on HVPS board is operated properly. If it is defective, replace the HVPS board.