PrintCopy.info service

Samsung SCX4729HD

Error Codes List page 2

  • Code: M2-1110
  • Display: Paper Jam inside machine
  • Description: A paper jam was detected at the feed sensor.
  • Remedy: 1) Remove the jammed paper. If the error persists, check the followings. (Refer to 4.1.3 Jam removal) 2) Check if the feed/regi sensor connector is connected properly. 3) Check if the regi./feed actuator works normally. If it is defective or broken, replace it.
  • Code: M2-2110, M2-2310
  • Display: Paper Jam top of duplex Paper Jam bottom of duplex
  • Description: A paper jam was detected in the duplex area.
  • Remedy: 1) First, remove the jammed paper. (Refer to 4.1.3 Jam removal) 2) Check if the paper in tray is loaded properly. Adjust the guide. Check the machine setting is normal for paper. 3) Check if the Guide-Change Duplex of the rear cover is defective or broken. Check if the rib form of the rear cover is normal.
  • Code: M3-1110
  • Display: Paper Jam in exit area
  • Description: A paper jam was detected in the exit area.
  • Remedy: 1) Open the rear cover. Remove the jammed paper. (Refer to 4.1.3 Jam removal) 2) Check if the Guide-Change Duplex of the rear cover is defective. 3) Check if the exit sensor and actuator is working normally.
  • Code: M3-2130
  • Display: Output bin full Remove paper
  • Description: The machine detected that the output tray has got full or the bin-full sensor is defective.
  • Remedy: 1) Remove the paper on the output tray. (The maximum loading capacity is 150 sheets based on standard paper(80g/m2).) 2) Check if the Bin-full Sensor connector is connected properly. Reconnect it or replace the Bin-full sensor.
  • Code: S1-3212
  • Display: Error #S1-3212 Turn off then on
  • Description: The Motor Control chip on the main board does not work normally.
  • Remedy: 1) Turn the machine off then on. 2) If the problem persists, replace the main board.
  • Code: S1-5221
  • Display: Install wireless NIC
  • Description: The communication error between the main board and the wireless board has occurred.
  • Remedy: Check if the connection between the main board and the wireless board is normal. If the connection is OK, replace the part in this order. (Flat cable -> Wireless board -> Main board)
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us