Description: Strange characters are displayed on the OPE Panel and buttons are not operated.
Causes: 1. Clear the memory.(see page 6.5.3) 2. Check if OPE HARNESS is connected to the Connection B'd correctly.
Remedy: 1. Try again after clearing the memory. 2. After confirming that OPE HARNESS is connected to the Connection B'd correctly, if it is so, then replace the OPE Ass’y and Main Board in sequence.
Code: 08
Display: Defective LCD Operation
Description: Defective LCD Operation
Causes: 1. Clear the memory. (See page 6.5.3). 2. Confirm to catch a click sound, while a key on the OPE panel is pressed on.
Remedy: 1. The key is wrong itself or wrongly assembled. 2. Even after the key has been replaced, it is still wrong, try to replace the OPE Ass’y and the Main B'd in sequence.
Code: 09
Display: Not functioning of the fuser gear due to melting away
Description: The Motor breaks away from its place due to gear melting away.
Causes: 1. Check the Heat Lamp.
Remedy: 1. Replace the Fuser. 2. Replace the Main PBA. 3. Replace the SMPS.
Code: 10
Display: Paper Empty
Description: The paper lamp on the operator panel is on even when paper is loaded in the cassette.
Causes: 1. Bending or deformation of the actuator of the paper sensor. 2. The function of the Main PBA is defective Perform Engine Test Mode : Perform Engine Test Mode diagnostic code 2.
Remedy: 1. Replace the defective actuator. 2. Replace the Main PBA.
Code: 11
Display: Paper Empty without indication
Description: The paper lamp on the operator panel does not come on when the paper cassette is empty.
Causes: 1. Bending or deformation of the actuator of the paper sensor. 2. The function of the Main PBA is defective Perform.
Remedy: 1. Replace the defective actuator. 2. Replace the Main PBA.
Code: 12
Display: Door Open
Description: The ERROR lamp is on even when the print Door is closed.
Causes: 1. The hook lever in the Front Cover may be defective. 2. Check the Connector(CN1) and Circuit of the Cover Switch department in the Main PBA.
Remedy: 1. Replace the hook lever, if defective. 2. Check the insertion of the Door Open S/W Connect. 3. Replace the Main PBA or Door Open S/W.