Description: Tool Carriage Disconnection Error Machine fails to disconnect the Tool Carriage from the Head Carriage.
Causes: Disorder of Cap Motor Loose of Connection Part Fault of the Limit Position Initialize value Limit Sensor does not work correctly or is broken.
Remedy: 1) Check the mechanical Backlash or loose with the Tool Carriage part. 2) Lock Position Adjustment 3) Limit Position and Cut Down Position Initialize 4) Limit Sensor Replacement
Code: 0107
Description: Unset up of the Linear Encoder Linear Encoder Setup has not been done.
Causes: Linear Encoder Setup has not been done.
Remedy: 1) Carry out Linear Encoder Setup.
Code: 0109
Description: Wiper Protection Error Even though the machine carries out the regular movement, the output of the Wiper Origin Sensor does not reach the expected value
Causes: Disorder of Wiper Origin Sensor Fault of Wiper Unit Fault of Wiper Origin Sensor Cut-line or short-circuit of Cable and Flexible Cable
Remedy: 1) Wiper Origin Motor Replacement 2) Wiper Unit Replacement 3) Wiper Origin Sensor Replacement 4) Cable and Flexible Cable Replacement
Code: 0110
Description: Linear Encoder Error Input value from Linear Encoder is not changed when Linear Encoder is set up the Origin. When Motor stops during printing, Motor does not complete the movement which is supposed to be done.
Causes: Read error of Linear Encoder Read error of Encoder on Scan Motor side Wire is not fixed to Head Carriage firmly.
Remedy: 1) Confirm whether Encoder Scale is between the slit of Encoder Module in a whole width of the machine. 2) Linear Encoder Replacement 3) Scan Motor Replacement 4) Confirm Cable Connection between Linear Encoder Board and Print Carriage Board. 5) Confirm Connection between Wire and Head Carriage.
Code: 0111
Description: Tool / Crop Error This error occurs when the machine performs the Auto Crop Mark Detection or the Auto Print / Cut adjustment without the Tool / Crop Mark Sensor Adjustment.
Causes: Tool / Crop Mark Sensor Adjustment has not been performed
Remedy: 1 ) Tool / Crop Mark Sensor Adjustment
Code: 0120
Description: Thermistor Error (Print Heater) Thermistor of the Print Heater doesn't work correctly.
Causes: Thermistor of the Print Heater is broken. There is a cut-line/short in the wiring of the Thermistor.
Remedy: 1) Check the wirings of Print Heater 2) Thermistor Replacement