Description: ASIC memory abnormal
• An error occurred while writing to or reading the SRAM on the Control Board (PWB-C).
Remedy: 1 Turn the copier off, then on again. 2 Check the connection of the memory on the PWB-P, and then correct it if necessary. 3 Replace PWB-P.
Code: C1300
Description: Polygon mirror motor error
• The LOCK signal is not detected within a predetermined period of time that begins 1 sec. after the Polygon Motor has been energized. • No new LOCK signal is detected for a 1-sec. period that begins 1.5 sec. after the first LOCK signal was detected. • The LOCK signal is not detected for a continuous 0.5sec. period in a state in which the Polygon Motor runs stably. • The LOCK signal remains ON for a continuous 5-sec. period or more when the Polygon Motor remains deenergized.
Remedy: 1 Check cables for connection and correct as necessary. 2 Replace PH Unit. 3 Replace PWB-P.
Code: C133B
Description: Communication with option error
• Communication could not be established with the Controller Control Board within 5 seconds while printing.
Remedy: 1 Replace PWB-P.
Code: C133C
Description: Modem error
• A malfunction occurred in the Modem
Remedy: 1 Replace NCU.
Code: C133D
Description: ROM checksum error
• A malfunction occurred in the ROM.
Remedy: 1 Replace PWB-P.
Code: C13F0
Description: Laser error
• The laser output exceeds the upper limit value. • The laser output remains lower than the lower limit value.
Remedy: 1 Check cables for connection and correct as necessary. 2 Replace PH Unit. 3 Replace PWB-P.