Description: An error has occurred during a firmware upgrade.
Remedy: 1. Reinstall the firmware. 2. If the problem persists, contact HP Support.
Code: -
Display: RAM DISK IS WRITE PROTECTED
Description: The file system is protected and no new files can be written to it.
Remedy: 1. To enable writing to the RAM disk memory, use HP Web Jetadmin to turn off write protection. 2. To remove this message from the display, press "OK"
Code: -
Display: RFU LOAD ERROR
Description: An error has occurred during a firmware upgrade.
Remedy: 1. Reinstall the firmware. 2. If the problem persists, contact HP Support.
Code: -
Display: STANDARD TOP BIN FULL
Description: The output-bin-full sensor (PS4) is signalling that the bin is full.
Remedy: 1. Empty the output bin. Printing resumes automatically. 2. If the problem persists, verify that the connector at sensor PS4 is fully seated. The other end of the wiring is hard-wired to the ECU.
Code: 10.10.00
Display: 10.10.00 ERROR
Description: The device cannot read or write to the print cartridge e-label, or the e-label is missing from the print cartridge.
Remedy: 1. Verify that a genuine HP print cartridge is installed in the device. 2. Install another print cartridge. 3. Verify that the memory tag PCA is installed in the device. 4. Verify that the memory tag connector is firmly seated in connector J510 on the ECU. You might have to remove the main cooling fan to see this connection.
Code: 10.32.00
Display: 10.32.00 - Unauthorized Supply
Description: A supply has been installed that does not pass the authentication test for genuine HP supplies.
Remedy: If you believe you purchased a genuine HP supply, visit us at www.hp.com/go/ anticounterfeit. Any repair required as a result of using non-HP supplies or unauthorized supplies are not covered under warranty. HP cannot ensure the accuracy or the availability of certain features. To continue printing, touch OK.