Description: An error has occurred in the scanner.
Remedy: 1. Make sure that the scanner lock is in the unlocked position. 2. Turn the device off and then on. 3. Check the cable connections between the ADF/scanner assembly and the formatter. 4. If this message persists, replace the scanner assembly. 5. If, after replacing the scanner assembly, the message persists, replace the formatter
Code: 40
Display: 40 EIO <X> bad transmission To continue touch OK
Description: The connection between the device and the EIO card in the specified slot has been broken.
Remedy: Touch OK to clear the error message and continue printing. Check the EIO connection.
Code: 40
Display: 40 Embedded I/O bad transmission To continue touch OK
Description: A temporary printing error has occurred.
Remedy: 1. Turn the device off, and then turn the device on. 2. If this message persists, replace the formatter
Code: 41.3
Display: 41.3 - Load tray <XX> To use another tray, touch OK
Description: The specified tray does not contain the specified media size.
Remedy: Touch OK to use a tray that contains media of the correct size.
Code: 41.3
Display: 41.3 - Load tray <XX>: <Type>, <Size>
Description: The specified tray is loaded with media that is longer or shorter in the feed direction than the size configured for the tray.
Remedy: Touch OK to display Tray <X> Size. Reconfigure the size in a tray so that the device will use a tray that is loaded with the size of media required for the print job. If the message does not clear automatically from the control-panel display, turn the device off, and then turn the device on.
Code: 41.X
Display: 41.X Error To continue touch OK
Description: A temporary printing error occurred. X description 2 beam detect misprint 8 fuser too hot
Remedy: 1. Touch OK to clear the error. If the error is not cleared, turn the device off, and then turn the device on. 2. If the message persists, replace the fuser