Causes: A Type-B board lower than level 2 is installed.
Remedy: Remove the installed Type-B board.
Code: 00010037
Description: Head thermistor error
Causes: • The head thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C. • The Head FFC is disconnected, or its contact is poor.
Remedy: 1. Check the connection status of the Head FFC and correct it if necessary. 2. Replace the PRINT HEAD .
Code: 00010038
Description: Transistor thermistor error
Causes: • The transistor thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C.
Remedy: Replace the BOARD ASSY., MAIN .
Code: 0001003E
Description: Pressure Sensor failure
Causes: • The Pressure Sensor is ON when an ink pressurizing operation is not performed. (disconnection of the Pressure Sensor connector, malfunction of the Pressure Sensor, or Main Board failure) • The inside pressure cannot be reduced to the same level as atmospheric pressure. (valve failure, Regulator Solenoid failure, Pressure Tube failure, or Main Board failure)
Remedy: 1. Reconnect the Pressure Sensor connector securely. 2. Connect the Pressure Tube. 3. Replace the PUMP ASSY., SUPPLY . 4. Replace the BOARD ASSY., MAIN .
Code: 0001003F
Description: The Pressure Motor reached its end of life.
Causes: The cumulative number of steps of the Pressure Motor reached the prescribed upper limit
Remedy: Replace the PUMP ASSY., SUPPLY ., and reset the life counter of the Pressure Pump Unit using the Adjustment Program.
Code: 00010040
Description: Printing position error
Causes: • Exact detection of printing positions is impossible due to dirt or scratches on the Timing Fence or the CR Encoder. • Malfunction of the program
Remedy: 1. Replace the SCALE, CR . 2. Replace the CR Encoder Sensor . 3. Execute the CR Encoder Sensor Adjustment . 4. Installing Firmware