Description: Failure of pressurizing
The printer causes this error and stops operation if it detects an abnormal condition of the Pressure Sensor (air leak from the pressurizing mechanism) during the power-on initialization operation or while performing ink supply operation.
Causes: • Pressure Motor failure • The connector of the Pressure Motor, Regulator Solenoid or Pressure Sensor is disconnected. • The harness of the Pressure Motor, Regulator Solenoid or Pressure Sensor is broken. • Regulator Solenoid failure (does not become ON) • Pressure Sensor failure • The Pressure Tube is disconnected. • The fuse for the Solenoid or the motor driver is blown. (on the Main Board)
Remedy: 1. Reconnect the connectors of the Pressure Motor, Regulator Solenoid or Pressure Sensor securely. 2. Connect the Pressure Tube. 3. Replace the PUMP ASSY., SUPPLY . 4. Replace the BOARD ASSY., MAIN .
Code: 0001001B
Description: Head driver (TG) temperature error
The printer causes this error and stops operation if it detects an abnormal internal temperature of the printhead by the thermistor in the head while performing printing operation without firing ink from the nozzles.
Causes: • The printhead internal temperature rises because of a printing operation without firing ink. • A breakdown of the printhead • Poor contact, short or disconnection of the tape electric wires • Main Board failure. (A/D of the CPU is damaged)
Remedy: 1. Check if the printer can recover from the error by turning it OFF and back ON. 2. Replace the PRINT HEAD . 3. Replace the BOARD ASSY., MAIN .
Code: 0001001D
Description: CR servo parameter error
The printer causes this error and stops operation when it detects that a voltage beyond the prescribed range is output to the CR Motor.
Causes:
Remedy: 1. Clean dirt or paper dust on the Timing Fence and check if it is damaged. 2. Execute the CR Timing Belt Tension Adjustment . 3. Replace the CR Encoder Sensor . 4. Replace the CR MOTOR ASSY. . 5. Replace the BOARD ASSY., MAIN .
Code: 0001001E
Description: PF servo parameter error
The printer causes this error and stops operation when it detects that a voltage beyond the prescribed range is output to the PF Motor.
Causes:
Remedy: 1. Clean dirt or paper dust on the Loop Scale and check if it is damaged. 2. Execute the PF Timing Belt Tension Adjustment . 3. Replace the PF Encoder Sensor . 4. Replace the PF MOTOR ASSY. . 5. Replace the BOARD ASSY., MAIN .
Code: 00010020
Description: CSIC reading/writing error
The printer causes this error and stops operation if it cannot load the information from the CSIC or write new information on the CSIC while running a power-ON/ OFF sequence or opening/closing the I/C Cover, or after finishing to print one page.
Causes:
Remedy: 1. Reconnect the CSIC FFC. 2. The memory chip on the ink cartridge is defective. (replace the ink cartridge) 3. Poor contact with the memory chip. • Replace the HOLDER ASSY., IC, RIGHT . • Replace the HOLDER ASSY., IC, LEFT . 4. Replace the BOARD ASSY., SUB; B ., Replace the BOARD ASSY., SUB; C . 5. Replace the BOARD ASSY., MAIN .
Code: 00010023
Description: RTC analyzing error
The printer causes this error and stops operation when it detects that the absolute date and time stored on the NVRAM is incorrect.
Causes:
Remedy: 1. Start up the printer in the Serviceman mode, and correct the date and time setting using the “RTC & USB ID & IEEE1394 ID” Basic Adjustment menu provided in the Adjustment Program. 2. Remove and reinstall the lithium battery. 3. Replace the lithium battery. Be sure to perform the RTC setting. 4. Replace the BOARD ASSY., MAIN .