Display: Hardware error. 03800500-2F43 Turn off printer,wait, then turn on again.
Description: When the result of non-ejection detection is as follows: Complete non-ejection (640 nozzles) of EVEN line or ODD line. -Error code assuming broken flexible cable or contact failure (data line).
Remedy:
Code: 2F44
Display: Hardware error. 03800500-2F44 Turn off printer,wait, then turn on again.
Description: When the result of non-ejection detection is as follows: More than half of 640 nozzles in EVEN line or ODD line have non-ejection (more than 320 nozzles). -Error code assuming a head failure such as broken heater board of head.
Remedy:
Code: 2F46
Display: Hardware error. 03130031-2F46 Turn off printer,wait, then turn on again.
Description: The shutter HP sensor did not respond at startup and at switching of platen shutter at printing.
Remedy: Check the platen shutter HP sensor (I/ O Display). Check/ replace the platen shutter drive unit or sensor
Code: 2F47
Display: Hardware error. 3800500-2F47 Turn off printer,wait, then turn on again.
Description: The optical axis of the head management sensor unit has been intercepted for some reasons. The amount of LED luminescence and the level of detection signal of diode light receiving sensitivity has gone beyond the predefined range. (determines the level of APCCHK)(It's not a problem of printhead or ink supply system.)
Remedy: 1. Check whether any foreign matter such as paper slip exists on the head management sensor optical axis. 2. Light interception due to ink accumulation.-> Remove the ink/ Replace the unit. 3. Check connection of the head management sensor's connector. 4. Main controller PCB (Check the fuse/ Replace the PCB.) 5. A large amount of ink mist has been attached to optical element. 6. Replace the head management sensor.
Code: 2F48
Display: Hardware error. 03130031-2F48 Turn off printer, wait, then turn on again.
Description: VHT (heater drive drive power supply for printhead) error VHT has gone below or above the rating.
Remedy: iPF6300 series 1. Replace the printhead. 2. Replace the main controller PCB. iPF8300 series 1. Replace the printhead. 2. Replace the CR relay board. 3. Check/ replace the long flexible cable. 4. Replace the main controller PCB.
Code: 2F49, 2F50, 2F51
Display: Hardware error. 03130031-xxxx Turn off printer, wait, then turn on again.
Description: Printhead short-circuited detected. Prior to VH power on, it has been detected that the printhead had been damaged due to paper jam etc, and ink went inside the terminal area causing near short-circuit. 2F49: L side printhead 2F50: R side printhead 2F51: LR both printhead
Remedy: iPF6300 series 1. Replace the printhead 2. Replace the main controller PCB. iPF8300 series 1. Replace the printhead 2. Replace the CR relay board 3. Check/ replace the long flexible cable. 4. Replace the main controller PCB.