PrintCopy.info service

Riso FR3910

Error Codes List page 1

  • Code: T1
  • Description: Main Motor Lock
  • Causes: • In 3 seconds from turning ON of the Main motor, the A detection sensor light path is still held blocked.
    • In 8 seconds from turning ON of the Main motor, the A detection sensor is not blocked.
  • Remedy: Press <ALL RESET> key. Press <START> key.
  • Code: T10
  • Description: Malfunction Image Processing PCB
  • Causes: • When the scanning contrast adjustment signal is not output from the image processing PCB.
  • Remedy: OFF -> ON
  • Code: T11
  • Description: Pressure Control Motor Lock
  • Causes: • In 100ms from turning ON of the Pressure control motor, the Encoder sensor cannot detect a pulse.
    • In 5 seconds from turning ON of the Pressure control motor, the Pressure centering sensor is not turned ON/OFF.
  • Remedy: Press <ALL RESET> key.
  • Code: T12
  • Description: CALL SERVICE
  • Causes: • Malfunction of Trimming PCB
    • When the TOP signal is not output from the Trimming PCB 2
  • Remedy: OFF -> ON
  • Code: T13
  • Description: Cutter Motor Lock
  • Causes: • After master cutting retrial with the drum held in C-2 position, when the Master positioning sensor is in light-receiving state. (Master cutting has failed in the 2nd time.)
  • Remedy: Drawer connector OFF (Pull out the drum.)
  • Code: T14
  • Description: Clamp Error (2)
  • Causes: • If the actuator of the Clamp safety switch is not depressed when the Clamp solenoid is not in operation.
  • Remedy: Press <ALL RESET> key.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us