PrintCopy.info service

Canon NP8530

Error Codes List page 1

  • Code: E000
  • Description: The surface temperature of the fixing assembly upper roller fails to rise by a specified value within 90 sec after power-on. The surface temperature of the fixing assembly upper roller fails to reach 150 C within 8 min after power -on. The surface temperature of the fixing assembly upper roller fails to reach 180 C within 5 min after it has reached 150 C. The surface temperature of the fixing assembly upper roller falls below 50 C in standby.
  • Code: E001
  • Description: The surface temperature of the fixing assembly upper roller exceeds 250 C.
  • Code: E005
  • Description: The cleaning belt inside the fixing assembly has been taken up more than a specified length.
  • Code: E010
  • Description: After generation of the main motor drive signal, two or more pulses are not received within 2 sec.
  • Code: E020
  • Description: The accumulative time during which the toner supply signal (TSP) has been generated by the developing assembly reaches 3 min.
  • Code: E050
  • Description: The holding tray home position signal (THP) is not generated within 4 sec while the holding tray motor drive signal (TMDP1,2) is being generated. The holding tray home position signal (THP) is generated 1 sec or more while the holding tray motor drive signal (TMDP1.2) is being generated.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us