Description: Error in temperature rising of Fixing Assembly
Causes: Temperature of the Fixing Assembly did not reach a certain temperature within the specified period of time.
Remedy: 1. Check the connection of connectors between the Fixing Assembly and the Engine Controller PCB. 2. If the connector at the Fixing Assembly side does not have induction while the assembly is removed, replace the assembly. 3. Replace the Engine Controller PCB.
Code: E001 0000
Description: Abnormal high temperature of Fixing Assembly
Causes: It was detected that the temperature of the Fixing Assembly was abnormally high.
Remedy: 1. Check the connection of connectors between the Fixing Assembly and the Engine Controller PCB. 2. If the connector at the Fixing Assembly side does not have induction while the assembly is removed, replace the assembly. 3. Replace the Engine Controller PCB.
Code: E003 0000
Description: Abnormal low temperature of Fixing Assembly
Causes: After Heater turns on, Main Thermistor detected a temperature of 120 deg C or lower for more than 20 seconds.
Remedy: 1. Check the connection of connectors between the Fixing Assembly and the Engine Controller PCB. 2. If the connector at the Fixing Assembly side does not have induction while the assembly is removed, replace the assembly. 3. Replace the Engine Controller PCB.
Code: E004 0000
Description: Error in fixing power supply drive circuit
Causes: Error in either the Fixing Heater or the Main Motor
Remedy: 1. Check the connection of connectors between the Fixing Assembly and the Engine Controller PCB. 2. If the connector at the Fixing Assembly side does not have induction while the assembly is removed, replace the assembly. 3. Reconnect the connector on the Main Motor. 4. Replace the Main Motor. 5. Replace the Engine Controller PCB.
Code: E014 0000
Description: Main motor error
Causes: Main motor failure is detected.
Remedy: 1. Reconnect the connector on the Main Motor. 2. Replace the Main Motor.
Code: E06F 0068
Description: EEPROM communication error
Causes: EEPROM communication error
Remedy: 1. Reconnect the connector on the Engine Contoroller PCB. 2. Replace the Engine Contoroller PCB.