Description: There is a fault in the software program of the video controller.
Causes:
Remedy: - Turn off and then back on the power. - Replace the video controller board.
Code: A7-XX
Description: There is an error in the software program of the video controller.
Causes:
Remedy: 1. Turn off and then back on the power. 2. If remedy 1 above fails, replace the controller board.
Code: D7-XX
Description: A fault has occurred the firmware of the PCL translator.
Causes:
Remedy: 1. Turn off and then on the power. 2. If remedy 2 above fails, replace the controller board.
Code: E000-0000
Description: Fixing fault
Causes: After the fixing heater has gone on, the reading is not -5 deg C of the target temperature within 75 sec. Cause The fixing film unit is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.
Code: E000-0001
Description: Fixing fault
Causes: After the fixing heater has gone on, the reading of the main thermistor is not 50 deg C within about 1.5 sec. Cause The fixing film unit is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.
Code: E001-0000
Description: Fixing error high temperature
Causes: A temperature of the main thermistor is detected 240 degrees Celsius for one second. Cause The main thermistor is faulty. The engine controller PCB is faulty.
Remedy: - Replace the fixing film unit. - Replace the engine controller PCB.