PrintCopy.info service

Riso GR3770

Error Codes List page 1

  • Code: E 01
  • Description: Main Motor Lock
  • Causes: Displayed to interrupt the machine operation:
    1) If the Drum position A is still detected by the Position A detection sensor 2 seconds after the Main motor started.
    2) If the Drum position A hasn’t been detected by the Position A detection sensor within 5 seconds after the Main motor is started.
  • Remedy: Press ALL RESET button.
  • Code: E 02
  • Description: Elevator Motor Lock
  • Causes: Displayed to interrupt the machine operation:
    1) If the actuator of the Elevator upper limit sensor is not raised within 9 seconds after the Elevator motor started to raise the Paper feed tray.
    2) If the light path of the Elevator lower limit sensor is not blocked within 9 seconds after the Elevator motor started to lower the Paper feed tray.
    3) If the light path of the Elevator lower limit sensor is blocked 2 seconds after the Elevator motor started to raise the Paper feed tray.
    4) If the actuator of the Elevator upper limit sensor is still raised 2 seconds after the Elevator motor started to lower the Paper feed tray.
  • Remedy: Press ALL RESET button.
  • Code: E 03
  • Description: Clamp Error 1
  • Causes: Displayed to interrupt the machine operation:
    1) If the actuator of the Clamp safety switch is still depressed 4 seconds after the Clamp solenoid was activated (turned on).
    2) If the actuator of the Clamp safety switch has not been depressed within 4 sec. after the Clamp solenoid was released (turned off).
    3) If the Angular magnet has not been detected by the Angular sensor (either 0° or 180°) within 8 seconds after the Clamp motor started rotating.
    4) If the actuator of the Clamp safety switch is not depressed when the Clamp solenoid is not in operation.
  • Remedy: Press ALL RESET button.
  • Code: E 04
  • Description: Ink Overflow
  • Causes: Displayed to interrupt the machine operation:
    1) If the Overflow sensor detects excessive ink in the Squeegee unit.
  • Remedy: Overflow sensor OFF
  • Code: E 05
  • Description: Print Positioning Motor Lock
  • Causes: Displayed to interrupt the machine operation:
    1) If the Vertical centering sensor status has not been changed from ON to OFF (or OFF to ON) within 12 seconds after the Print positioning motor started rotating.
  • Remedy: Press ALL RESET button.
  • Code: E 06
  • Description: Pressure Detection Sensor Malfunction
  • Causes: Displayed to interrupt the machine operation:
    1) If the Pressure detection sensor status has not been changed from ON to OFF (or OFF to ON) within 8 seconds after the Main motor started rotating.
  • Remedy: Press ALL RESET button.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us