PrintCopy.info service

Konica-Minolta bizhub 215

Error Codes List page 1

  • Code: C0211
  • Description: Bypass tray up/down failure
    - While the bypass lift sensor (PS2) is in the OFF state after the power is turned ON, output is finished, or a paper jam is cleared, PS2 is not turned ON within the given time after the bypass pick-up solenoid (SD1) has been turned ON. Then SD1 is turned ON again, but PS2 cannot be turned ON within the given time.
    - When the bypass lift sensor (PS2) is in the ON state, PS2 is not turned OFF within the given time after the bypass pick-up solenoid (SD1) has been turned ON.
  • Remedy: 1 Check the connector between M1-MFPB P006 for proper connection and correct as necessary. 2 Check M1 for correct drive coupling and correct as necessary. 3 Check the connector between CL1-relay CN3-relay CN6- MFPB P008 for proper connection and correct as necessary. 4 CL1 operation check. 5 Check the connector between SD1-relay CN4-relay CN6- MFPB P008 for proper connection and correct as necessary. 6 M1 operation check. 7 SD1 operation check. 8 Change MFPB.
  • Code: C03FF
  • Description: Faulty model setting
    - “Model Setting” of “Adjust” available from the Service mode is incorrectly set.
  • Remedy:
  • Code: C2351
  • Description: Cooling fan motor malfunction
    - The fan lock signal remains HIGH for a predetermined continuous period of time while the cooling fan motor (FM2) is turning.
  • Remedy: 1 Check the connector between FM2-relay CN27-MFPB P013 for proper connection and correct as necessary. 2 Check the fan for possible overload and correct as necessary. 3 FM2 operation check. 4 Change MFPB.
  • Code: C2557
  • Description: Abnormally low toner density detected TCR sensor board
    - The T/C ratios detected by the TCR sensor board (TCRSB) are below the threshold for the detection of abnormally low T/C ratio for three successive times. However, if a toner empty condition is detected, this abnormality is not detected.
  • Remedy: 1 Check to see if developer is available. 2 Check the connector between TCRSB-relay CN14-MFPB P010 for proper connection and correct as necessary. 3 Change TCRSB. 4 Change MFPB.
  • Code: C2558
  • Description: Abnormally high toner density detected TCR sensor board
    - The T/C ratios detected by the TCR sensor board (TCRSB) are above the threshold for the detection of abnormally high T/C ratio for three successive times.
    - The connector between MFPB to TCRSB is disconnected.
  • Remedy: 1 Check to see if developer is available. 2 Check the connector between TCRSB-relay CN14-MFPB P010 for proper connection and correct as necessary. 3 Change TCRSB. 4 Change MFPB.
  • Code: C255C
  • Description: TCR sensor board adjustment failure
    - When TCR AUTO ADJUST is performed, the difference between the TCR sensor output voltage determined by TCR AUTO ADJUST and the standard voltage is greater than the threshold value.
  • Remedy: 1 Check to see if developer is available. 2 Check the connector between TCRSB-relay CN14-MFPB P010 for proper connection and correct as necessary. 3 Change TCRSB. 4 Change MFPB.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us