PrintCopy.info service

Canon iR6570

Error Codes List page 1

  • Code: E000-0000
  • Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    After power-on, the reading of the main thermistor does not increase to 70 deg C or higher within 20 sec.
  • Remedy: - Replace the main/shutter thermistor. - Replace the DC controller PCB.
  • Code: E000-0010
  • Description: The heater fails to heat. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    The power has been turned off and then on without resetting the error.
  • Remedy: - Reset the error. (COPIER>FUNCTION>CLEAR>ERR)
  • Code: E001-0001
  • Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    There is an error or an open circuit in the main thermistor, shutter thermistor, or sub thermistor.
  • Remedy: - Check the connector of each thermistor for any fault in connection and wiring. - Replace the thermistor in question. - Replace the DC controller PCB.
  • Code: E001-0002
  • Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    The reading of the main thermistor, shutter thermistor, or sub thermistor is 230 deg C or higher for 2 sec.
  • Remedy: - Replace the thermistor in question. - Replace the DC controller PCB.
  • Code: E001-0003
  • Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    The reading is not 150 deg C or higher or 210 deg C or lower within 30 sec.
  • Remedy: -Cheak the connecting of the main/ sub/ shutter thermistors. -Check the mounting of the main/ sub/ shutter thermistors. -Exchange the main/ sub/ shutter thermistors. -Exchange the DC controller PCB.
  • Code: E001-0010
  • Description: There is an abnormal rise in temperature. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
    The power has been turned off and then back on without resetting the error.
  • Remedy: - Reset the error. (COPIER>FUNCTION>CLEAR>ERR)
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us