Zebra 105SL Error Codes List page 1 from 4

  • Code: 01
  • Display:
  • Description: No LEDs light and no display.
  • Causes: AC power source not live. Power cord not fully inserted into power source or power entry module. AC fuse blown. AC fuse blown. Power supply faulty. Main logic board failure.
  • Remedy: Power cord not fully inserted into power source or power entry module. Plug power cord into a live AC source. Make sure that power cord is fully inserted into the AC receptacle and the power entry module. Replace AC fuse. Replace power supply. Replace main logic board.
  • Code: 02
  • Display:
  • Description: All LEDs light, but nothing displays on LCD and printer does not operate.
  • Causes: Main logic board or Flash faulty.
  • Remedy: Download new Flash or replace the main logic board.
  • Code: 03
  • Display:
  • Description: All LEDs flash on and off.
  • Causes: No significant amount of DRAM tested good.
  • Remedy: Replace the main logic board.
  • Code: 04
  • Display:
  • Description: Take Label LED flashing.
  • Causes: Printer misconfigured for Peel-Off Mode.
  • Remedy: If peel-off is desired, check take label sensor.
  • Code: 05
  • Display:
  • Description: Printer locks up while running Power-On Self Test.
  • Causes: Main logic board failure.
  • Remedy: Replace main logic board.
  • Code: 06
  • Display: EEPROM CHECKSUM INVALID
  • Description:
  • Causes: EEPROM checksum is incorrect.
  • Remedy: Replace the main logic board.
  • Code: 07
  • Display: ERROR CONDITION PAPER OUT
  • Description: Printer stops and ERROR LED flashes.
  • Causes: No media loaded or incorrectly loaded. Misadjusted media sensor. Maximum label length set shorter than label length. Printer set for non-continuous media, but continuous media is loaded.
  • Remedy: Load media correctly. Check media sensor position and sensitivity. Verify maximum label length setting is correct. Install proper media or reset printer for current media type.
  • Code: 08
  • Display: ERROR CONDITION RIBBON OUT
  • Description: Printer stops and ERROR LED flashes.
  • Causes: For Thermal Transfer: Ribbon not loaded or incorrectly loaded. or Ribbon sensor not sensing ribbon that is correctly loaded.
  • Remedy: 1. Load ribbon correctly. 2. Ensure snap plate is properly installed. 3. Perform media and ribbon sensor calibration.