PrintCopy.info service

Roland SJ1000 SolJet proII

Error Codes List page 1

  • Code: 0002
  • Description: Sub CPU Communication Error
    Disorder of communication with Sub CPU
  • Causes: Sub Board does not work correctly. Sub CPU does not work correctly. There is a bad connection between Main Board and Sub Board.
  • Remedy: 1) Check Cable Connection between Main Board and Servo Board. 2) Check Cable Connection between Servo Board, Heater Board. 3) Check Cable Connection of others on a Servo Board and Heater Board. 4) Servo Board Replacement 5) Heater Board Replacement 6) Main Board Replacement
  • Code: 0101
  • Description: Limit Position Erro
    rLimit Initialization in the Service Mode has not been done.
  • Causes: Limit Initialization in Service Mode has not been done.
  • Remedy: 1) Carry out Limit Position Initialize.
  • Code: 0102
  • Description: Limit Sensor Error
    Even though the machine carries out the regular movement, the output of the Limit Sensor does not reach the expected value.
  • Causes: Limit Sensor does not work correctly or is broken.
  • Remedy: 1) Limit Sensor Replacement 2) Check the mechanical Backlash or loose with the scanning axes.
  • Code: 0104
  • Description: Cap Unit Protection Error
    Even though the machine carries out the regular movement, the output of Cap Sensor does not become to reach the expected value.
  • Causes: Disorder of Cap Motor Fault of Cap Unit Fault of Cap Sensor Cut-line or short-circuit of Cable and Flexible Cable
  • Remedy: 1) Check Cable Connection of the Servo Board. 2) Check Cable Connection of the Junction Board. 3) Cap Motor Replacement 4) Cap Unit Replacement 5) Cap Sensor Replacement 6) Cable and Flexible Cable Replacement
  • Code: 0107
  • Description: Unset up of the Linear Encoder
    Linear Encoder Setup has not been done.
  • Causes: Linear Encoder Setup has not been done.
  • Remedy: 1) Carry out Linear Encoder Setup.
  • Code: 0108
  • Description: Wiper Unit Protection Errorder
    Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not reach the expected value.
  • Causes: Disorder of Wiper Height Sensor Fault of Wiper Unit Fault of Wiper Height Sensor Cut-line or short-circuit of Cable and Flexible Cable
  • Remedy: 1) Wiper Height Motor Replacement 2) Wiper Unit Replacement 3) Wiper Height Sensor Replacement 4) Cable and Flexible Cable Replacement
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us