PrintCopy.info service

Ricoh DX4443CP

Error Codes List page 1

  • Code: E-00
  • Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
  • Causes: Clamper drive Clamper sensors Clamper motor
  • Code: E-01
  • Description: Cutter error The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.
  • Causes: Cutter drive Cutter switch Cutter motor
  • Code: E-02
  • Description: Paper Table Drive error The paper height sensor or the table lower limit sensor does not turn on within 7.5 seconds after the table motor turn on.
  • Causes: Table Drive Table motor Table height sensor Table lower sensor
  • Code: E-04
  • Description: Thermal Head Overheat The temperature of the thermal head is grater than 54C when the Start key is pressed.
  • Causes: Overheat (wait for the thermal head to cool down) Thermal head
  • Code: E-06
  • Description: Main Motor error The CPU cannot detect the master eject position sensor (drum HP) signal within 5.0 seconds after the main motor turn on.
  • Causes: Main motor drive Main motor Motor drive board Master eject position sensor
  • Code: E-09
  • Description: Thermal Head Thermistor Open The thermistor output voltage is over 4.9 volts.
  • Causes: Thermal head thermistor Thermal head connector
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us