PrintCopy.info service

Lexmark X466dwe

Error Codes List page 1

  • Code: 200.00
  • Description: Paper jam around input sensor.
  • Remedy: Remove the PC kit and paper or debris at the input sensor.
  • Code: 200.01
  • Description: Classic input jam. The media is too long over the input sensor. Possible causes include multi-sheet feed, tray size sensing problem, and media slippage.
  • Remedy: First, remove the PC kit and paper or debris at the input sensor. Then, inspect the flag on the input sensor. It should rotate freely. Replace the sensor if necessary. Finally, check the paper size settings in the printer and the driver.
  • Code: 200.02
  • Description: The main input sensor never became uncovered from the printer and the driver. the sheet ahead.
  • Remedy: First, remove the PC kit and paper or debris at the input sensor. Then, inspect the flag on the input sensor. It should rotate freely. Replace the sensor if necessary. Finally, check the paper size settings in the printer and the driver.
  • Code: 200.03
  • Description: The video never started on the page at the input sensor within two inches after hitting the input sensor
  • Remedy: Printhead Note: New printhead must be aligned. See “Printhead assembly electronic adjustment”. Turn the printer off. Disconnect the printhead cables from J12 and J8 on the controller board. Turn the printer on with the front door closed. On the controller board, verify +5 V dc on pin 10 at J12 and +5 V dc on pins 1, 2, and 3 at J8. Verify grounds on pins 2, 4, and 7 at J12 and on pin 4 at J8. •If voltages or grounds are incorrect, then check the controller board. See “Controller board service check” for more information. •If voltages are correct, then replace the printhead (comes with cables).
  • Code: 200.04
  • Description: The media at the input sensor before interrupt occurred–not enough time elapsed since the printhead started to expect the printhead mirror motor lock. Possible causes include bouncy sensor or exceptionally fast pick– perhaps due to media prestaged in the source tray.
  • Remedy: Carefully remove the tray and notice if the leading edge of the media is pointed upward and out of the tray. If so, then inspect the tray wear strips and replace if necessary. Inspect the input sensor flag and replace it if it does not rotate freely or is too loose.
  • Code: 200.06
  • Description: Imaged page not expected page (bouncy passthru sensor)
  • Remedy: Remove the toner cartridge/PC kit. At the front, remove the upper front guide, and inspect the flag on the manual input sensor. If the flag is loose, then replace it. See “Media manual input sensor removal”.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us