Kyocera TASKalfa 750c

Error Code:

Code: E010
Description: Jam not reaching the fuser transport sensor The paper which has passed through the fuser unit does not reach the fuser transport sensor.
Remedy: 1. Check if there is any paper on the transport path or in the fuser unit. Remove it if there is. * If the error still occurs, check the following. 2. Is the fuser transport sensor working? (Perform the input check: 03-[FAX]OFF/[2]/[C]). * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN333 on the LGC board is disconnected from the fuser transport sensor or the harnesses are open circuited. Correct if any. 4. Replace the fuser transport sensor. 5. Replace the LGC board. 6. Check if there is any abnormality on the paper transport path in the fuser unit. Correct it if there is. 7. If jams occur on the back side in duplex printing, change the media type mode to the recycled paper mode, and then check if there are still jams. (When this type of jam occurs on heavily curled paper during duplex printing, the jam may be resolved by selecting the recycled paper mode.) 8. Change the 2nd transfer bias offset value as shown below and then check if there are still jams. Change the default value 5 of each code below to 6 or 7. Color: 05-2935 Subcode: 7 Black: 05-2937 Subcode: 7

	Error Code
	Service Mode, Troubleshooting
	Parts Catalog
	Compatibility
	Downloads Files
	Home