PrintCopy.info service

Kyocera KM1510

Error Codes List page 1

  • Code: C011
  • Description: Backup memory data problem
    • Data in the specified area of the backup memory does not match the specified values.
  • Causes: Problem with the backup memory data. Defective backup RAM.
  • Remedy: Turn safety switch off and back on and run maintenance item U020 to set the contents of the backup memory data again. If the C011 is displayed after re-setting the backup memory contents, replace the backup RAM.
  • Code: C021
  • Description: Printer board communication problem
    • There is no reply after 20 retries at communication.
  • Causes: Poor contact in the connector terminals. Defective main PCB or printer board.
  • Remedy: Check the connection of connector CN20 on the main PCB and the connector on the printer board. Repair or replace if necessary. Replace the main PCB or printer board and check for correct operation.
  • Code: C040
  • Description: DIMM problem
    • Information on DIMM cannot be read out correctly at power-on.
  • Causes: Poor contact of the memory board. DIMM installed incorrectly. Defective DIMM.
  • Remedy: Check the insertion of the memory board**. Check if the DIMM is inserted into the socket on the memory PCB correctly. Replace the DIMM and check for correct operation.
  • Code: C041
  • Description: Bitmap problem
    • There is a problem with the data or address bus of the bitmap DRAM.
  • Causes: Poor contact of the memory board. DIMM installed incorrectly. Defective DIMM.
  • Remedy: Check the insertion of the memory board**. Check if the DIMM is inserted into the socket on the memory PCB correctly. Replace the DIMM and check for correct operation.
  • Code: C043
  • Description: DMA problem
    • DMA transmission of compressed, decompressed, rotated, relocated or blanked-out image data does not complete within the specified period of time.
  • Causes: Poor contact of the memory board. Defective main PCB or memory board.
  • Remedy: Check the insertion of the memory board**. Replace the main PCB or memory board and check for correct operation.
    **: Standard for 18 cpm copier/optional for 15 cpm copier.
  • Code: C100
  • Description: Exposure lamp problem
    • Check the CCD input value for the lighting status of the exposure lamp 100 ms after the exposure lamp is lit and the carriage is moved to the shading position. If the exposure lamp does not light, turn off the lamp. After 500 ms, light the lamp again and, a further 500 ms later, check the CCD input. The exposure lamp does not light after 5 retries.
  • Causes: Poor contact of the connector terminals. Defective exposure lamp. Defective main PCB or inverter PCB. Incorrect shading position. CCD PCB output problem.
  • Remedy: Check the connection of connector CN12 on the main PCB, and the continuity across the connector terminals. Repair or replace if necessary. Replace the exposure lamp. Replace the main PCB or inverter PCB and check for correct operation. Adjust the position of the contact glass (shading plate). If the problem still occurs, replace the scanner home position switch. Replace the ISU.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us