Description: The device administrator has enabled the control-panel security mechanism. You cannot modify control-panel settings in this circumstance. The message disappears after a few seconds, and the device returns to Ready or BUSY state.
Remedy: Contact the device administrator to change settings.
Code: -
Display: ACTION NOT CURRENTLY AVAILABLE ON TRAY X
Description: You are trying to set duplex registration for a tray that is configured for ANY SIZE or ANY CUSTOM. Duplex registration is not available when the tray size is set to either of these settings.
Remedy: Change the size setting for the tray.
Code: -
Display: CHOSEN PERSONALITY NOT AVAILABLE
Description: The device encountered a request for a personality that did not exist in the device.
Remedy: 1. Press "OK" to continue. 2. Try a different driver.
Code: -
Display: CLOSE TOP COVER
Description: Door switch SW501 is signalling that the cartridge door is open. If the cartridge door is open, the main motor will not rotate during device power-up.
Remedy: The wires for switch SW501 are hard-wired to the ECU. Verify that the wires from the ECU are installed on the correct terminals of switch SW501.
Code: -
Display: CLOSE TOP COVER AND FRONT DOOR
Description: Door switch SW501 is signalling that the cartridge door is open. If the cartridge door is open, the main motor will not rotate during device power-up.
Remedy: The wires for switch SW501 are hard-wired to the ECU. Verify that the wires from the ECU are installed on the correct terminals of switch SW501.
Code: -
Display: CODE CRC ERROR
Description: An error has occurred during a firmware upgrade.
Remedy: 1. Reinstall the firmware. 2. If the problem persists, contact HP Support.