HP LaserJet M3027 MFP Error Codes List page 3 from 7

Exploded Views and Parts List Free!

  • Code: 22
  • Display: 22 Embedded I/O buffer overflow To continue touch OK
  • Description: Too much data was sent to the embedded HP Jetdirect print server.
  • Remedy: Touch OK to print the transferred data. (Some data might be lost.)
  • Code: 22
  • Display: 22 USB I/O buffer overflow To continue touch OK
  • Description: Too much data was sent to the USB buffer.
  • Remedy: Touch OK to clear the error message. (Data will be lost.)
  • Code: 30.1.YY
  • Display: 30.1.YY Scanner failure
  • Description: An error has occurred in the scanner.
  • Remedy: 1. Make sure that the scanner lock is in the unlocked position. 2. Turn the device off and then on. 3. Check the cable connections between the ADF/scanner assembly and the formatter. 4. If this message persists, replace the scanner assembly. 5. If, after replacing the scanner assembly, the message persists, replace the formatter
  • Code: 40
  • Display: 40 EIO <X> bad transmission To continue touch OK
  • Description: The connection between the device and the EIO card in the specified slot has been broken.
  • Remedy: Touch OK to clear the error message and continue printing. Check the EIO connection.
  • Code: 40
  • Display: 40 Embedded I/O bad transmission To continue touch OK
  • Description: A temporary printing error has occurred.
  • Remedy: 1. Turn the device off, and then turn the device on. 2. If this message persists, replace the formatter
  • Code: 41.3
  • Display: 41.3 - Load tray <XX> To use another tray, touch OK
  • Description: The specified tray does not contain the specified media size.
  • Remedy: Touch OK to use a tray that contains media of the correct size.
  • Code: 41.3
  • Display: 41.3 - Load tray <XX>: <Type>, <Size>
  • Description: The specified tray is loaded with media that is longer or shorter in the feed direction than the size configured for the tray.
  • Remedy: Touch OK to display Tray <X> Size. Reconfigure the size in a tray so that the device will use a tray that is loaded with the size of media required for the print job. If the message does not clear automatically from the control-panel display, turn the device off, and then turn the device on.
  • Code: 41.X
  • Display: 41.X Error To continue touch OK
  • Description: A temporary printing error occurred. X description 2 beam detect misprint 8 fuser too hot
  • Remedy: 1. Touch OK to clear the error. If the error is not cleared, turn the device off, and then turn the device on. 2. If the message persists, replace the fuser