PrintCopy.info service

HP DesignJet T770

Error Codes List page 1

  • Code: 01.0:YZ
  • Description: Communication with Engine PCA failed
  • Remedy: 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Remove the Formatter and reinsert it again. Ensure that it connects properly in the Engine PCA connector. • Replace the Engine PCA. • Replace the Formatter.
  • Code: 01.1:YZ
  • Description: Error in the Engine PCA
  • Remedy: 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Replace the Engine PCA. 3. Replace the Formatter.
  • Code: 01.2:YZ
  • Description: Failure communicating with an Ink Supply
  • Remedy: 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Perform the Ink Delivery System diagnostic test. – If the test finds that the ink supply is defective, replace it. – If the test does not find any errors, remove all the ink supplies from the ISS and reboot the product. 3. Install the ink cartridges with the product booted in normal mode. Use the replacement option available from the Touch Control Panel and install the cartridges one by one. If an error appears after installing a supply, the last supply you installed is defective. Replace it. 4. Check that the cables between the Left Ink Supply Station and the Engine PCA are not damaged and are correctly connected. In case of any damage replace the cables; see Connecting the Data Harness and ISS Harness Cable 5. Replace the Left Ink Supply Station. See Left Ink Supply Station. 6. Replace the Engine PCA. See EE Box.
  • Code: 02.1:YZ
  • Description: Problem with the Carriage PCA
  • Remedy: 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the Trailing Cable is not damaged. Check that the Trailing Cable is correctly connected between the Engine PCA and Carriage PCA. 3. Replace the Carriage PCA. See Carriage PCA. 4. Replace the Trailing Cable and Carriage PCA Covers. 5. Replace the Engine PCA. See EE Box.
  • Code: 03.0:10
  • Description: Battery of Real Time Clock ran down
  • Remedy: Replace the battery.
  • Code: 03:YZ
  • Description: Problem with Power Supply Unit
  • Remedy: 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Replace the Power Supply Unit (PSU). See Power Supply Unit
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us