PrintCopy.info service

HP Color LaserJet 2550

Error Codes List page 1

  • Code: 01
  • Image:
  • Description: Accessory error. An error has occurred in the DIMM slot.
    The Attention light, Ready light, and Go light are blinking. The printer stops printing, and pressing any button has no effect.
  • Remedy: 1. Turn the printer off. CAUTION Inserting or removing DIMMs while power is supplied to the printer can damage the DIMMs. 2. Remove the DIMM and reinstall it to make sure that it is correctly installed. 3. Make sure that you are using a supported DIMM. See Accessories. 4. Move the DIMM to a different DIMM slot. If the DIMM works in a different slot, then DIMM slot 1 is malfunctioning. 5. To continue printing, remove the DIMM from DIMM slot 1.
  • Code: 02
  • Image:
  • Description: The printer has a service error.
    The Attention light, Ready light, and Go light are on.
  • Remedy: Press and hold (Go ) to see a secondary error light message, and then see the secondary error light messages in this table to identify the service error. You can also use the simulator in the printer driver or the event log messages to identify the service error.
  • Code: 03
  • Image:
  • Description: The Ready light is on.
    Scanner error. 50005
  • Remedy: 1. Turn the printer off and then back on. 2. Turn the printer off, and then reseat the laser/scanner cable. 3. Replace the laser/scanner
  • Code: 04
  • Image:
  • Description: The Attention light is blinking.
    Fan motor error. 50006
  • Remedy: 1. Turn the printer off. 2. Check cable connections to the fan. 3. Turn the printer back on. 4. If the error persists, replace the fan
  • Code: 05
  • Image:
  • Description: The Attention light is on.
    Engine communication error. 50007
    Dc controller memory error. 50021
    The formatter is not communicating with the printer engine (50007).
    The dc controller is faulty (50021).
  • Remedy: 1. Turn the printer off and then back on. 2. Check the connections to the formatter and the dc controller. 3. Replace the formatter. 4. Replace the dc controller. 5. Replace the laser/scanner
  • Code: 06
  • Image:
  • Description: The Ready and Go lights are on.
    Low fuser-temperature error 50008
    Slow fuser error 50009
    High fuser-temperature error 50010
    Fuser drive-circuit error 50015
  • Remedy: 1. Turn the printer off for approximately 20 to 30 minutes. 2. If the printer is plugged into a power-strip or a UPS, unplug it and plug the printer power cord directly into a wall socket. 3. Turn the printer back on. 4. If the error persists, replace the fuser
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us