Description: The fixing assembly is faulty.
The SSR used to drive the fixing heater has a short circuit (detection by hardware circuitry).
Remedy: - Replace the AC driver PCB. - Replace the DC controller PCB. Caution You will have to clear the error in service mode (COPIER>FUNCTION>CLEAR>ERR).
Code: E005-0000
Description: The absence of the fixing web is detected.
The length of the fixing web that has been taken up is more than a specific value and the fixing web length sensor (PS7) has detected the absence of the web for 5 sec or more.
Remedy: - Check the position of the fixing web detection lever. - Replace the fixing web. - Replace the fixing web length sensor. - Replace the DC controller PCB. Caution After replacing the fixing web, you will have to clear the two web counters in service mode (COPIER>COUNTER>MISC>FIX-WEB and COPIER>COUNTER>DRBL-1>FIX-WEB).
Code: E005-0010
Description: The absence of the fixing web is detected.
The power is turned off and then on without clearing the error.
Remedy: - Reset the counters of the two webs to zero in service mode (COPIER>COUNTER>MISC>FIX-WEB, COPIER>COUNTER>DRBL-1>FIX-WEB)
Code: E010-0000
Description: The rotation of the main motor is faulty.
No clock pulse arrive for 2 sec or more after the main motor drive signal (MMFG) has been generated.
Remedy: - Check if the connecter (J611, J612) of the main motor is mounted properly. - Check if the connector (J1720) of the relay PCB is mounted properly. - Replace the main motor. - Replace the relay PCB. - Replace the DC controller PCB.
Code: E012-0000
Description: The rotation of the drum motor is faulty.
No clock pulse arrives for 2 sec or more after the drum motor drive signal (DMFG) has been generated.
Remedy: - Check if the connector (J1720) of the relay PCB is mounted properly. - Check if the connector (J512) of the DC controller PCB is mounted properly. - Check if the connecter (J601, J602) of the drum motor is mounted properly. - Replace the drum motor. - Replace the DC controller PCB.
Code: E013-0000
Description: The lock of the waste toner feed screw is detected.
The waste toner feed screw fails to rotate normally, and the switch MSW2 is pressed multiple times within a specific period of time.
Remedy: - Re-mount the waste toner pipe. - Replace the waste toner pipe. - Replace the waste toner clog detecting switch. - Replace the DC controller PCB. Caution You will have to clear the error in service mode (COPIER>FUNCTION>CLEAR>ERR).